Control unit 24/36 Volt 15A - 250 / 350W - with and without hall sensors - UPG connection

- This universal control unit has the ability to operate at two different voltages in fact, it can work both at 24v and at 36v and it also has the particularity of being able to work both with motors with hall sensors (the 5/6 small wires that come out from the engine) that with engines that are not equipped with hall sensors.

- This controller ONLY INTERFACE with KT displays and components.

- This universal control unit works with all brushless motors (brushless) but hardly interfaces with the bike's standard displays.
- Can be mounted on: E-Bike, electric scooters, electric scooters, electric quads, scooters for the disabled. So on every electric vehicle that has a brushless motor (you can guess if the motor is brushless from the escape of three yellow, green and blue wires from the motor).
- We also recommend the purchase of our universal display to make sure the controller works properly.

Measurements:
LENGTH: 8.5 cm
TOTAL LENGTH: 9,5 cm
WIDTH: 5 cm
HEIGHT: 3 cm

Technical data:
MODEL: KT24/36ZWSRT-PXS24L
RATED VOLTAGE: DC24V/36V
RATED CURRENT: 7A
MAXIMUM CURRENT: 15A+-1A
LOW VOLTAGE PROTECTION: DC20/30+ - 0.5V
SPEED SET: 1-4.2V

For any technical information on assembly and compatibility, the technicians are available at 3206140014 also with whatsapp message. Capobranco Project is not responsible for tampering or incorrect installations. The control units branded CAPOBRANCO use the best components to provide the best quality and reliability Our control units, assembled by specialized technicians, are tested at the end of the production process and before shipment. On the control units for electric bikes, scooters and electric scooters, Capobranco Project guarantees a 1 year warranty Our products are stocked and shipped from our headquarters in Italy.