Control Unit Kit + LED Display + Universal Pas 24V 15A Brushless Motors

Universal kit composed of:

- 24V Normal Cable control unit
- 24V Led Multifunction Display
- Assisted pedaling Pas sensor.

NB: This kit can only be mounted complete with all its components and only and exclusively on brushless motors (brushless motors with 3 large wires plus 5/6 small ones at the motor output).

Technical specifications:

24/36 Volt 15A control unit with and without hall sensors
- This universal control unit has the ability to operate at two different voltages, in fact, it can work at both 24v and 36v and it also has the particularity of being able to operate both with motors with hall sensors (the 5/6 small wires coming out from the engine) and with engines that do not have hall sensors.
- This universal control unit works with all brushless motors (without brushes) but hardly interfaces with the bikes' serial displays.
- It can be mounted on: E-Bikes, electric scooters, electric scooters, electric quads, scooters for the disabled. So on every electric vehicle that has a brushless motor (one can guess if the motor is brushless from the exit of three yellow, green and blue wires from the motor).
- We also recommend the purchase of our universal display to make sure your controller works properly.

Measures:
LENGTH: 8.5cm
TOTAL LENGTH:10cm
WIDTH: 5cm
HEIGHT: 3cm

Technical data:
MODEL: KT24-36ZWSRT-XW02L
RATED VOLTAGE: DC24V/36V
RATED CURRENT: 7A
MAXIMUM CURRENT: 15A +- 1A
LOW VOLTAGE PROTECTION: DC20/30+ - 0.5V
SPEED SET: 1-4.2V

The CAPOBRANCO branded control units make use of the best components to provide the best quality and reliability. Our control units, assembled by specialized technicians, are tested at the end of the production process and before shipment. On the control units for electric bikes, scooters and electric scooters, Capobranco Project guarantees a 1-year warranty. Our products are stored and shipped from our headquarters in Italy.

24 Volt LED display model 880 - Standard connection
- This universal display can work with all brushless motors (without brushes) but hardly interfaces with the bikes' stock control units.
- This universal display does not necessarily interface with the bike's stock control unit, so we recommend purchasing the complete universal kit in case of difficulty

Technical data:
battery level
3 levels of assistance
6km/h function

PAS pedal assistance sensor KT-D12L with Normal Cable connection
This pedaling sensor (PAS) is mounted on the left side of the bike.
To install it, the crank must be disassembled and then reassembled by tightening the PAS well on the axis of the bottom bracket.

For any technical information on assembly and compatibility, the technicians are available on 3206140014 also with a whatsapp message. Capobranco Project is not responsible for tampering or incorrect installations. On the control units for electric bikes, scooters and electric scooters, Capobranco Project guarantees a 1-year warranty. Our products are stored and shipped from our headquarters in Italy.