Control Unit + LCD3 Display + Pas + Universal Wiring 36V 15A UPG Brushless Motors Kit

Universal kit consisting of:

- 24 / 36V UPG control unit
- 24/36 / 48V Lcd3 Multifunction display
- Pedal Assisted Pas sensor
- 1T4 wiring harness for display-brakes-accelerator - UPG

NB: This kit can only be assembled complete with all its components and only and exclusively on brushless motors (brushless motors with 3 large wires plus 5/6 small ones at the motor output).

Technical specifications:

24/36 Volt 15A control unit - with and without hall sensors - UPG connection
- This universal control unit has the ability to operate at two different voltages in fact, it can work both at 24v and at 36v and also has the particularity of being able to operate both with motors with hall sensors (the 5/6 small wires that come out from the motor) and with motors that are not equipped with hall sensors.
- This universal control unit works with all brushless motors (without brushes) but hardly interfaces with the standard bike displays.
- It can be mounted on: E-Bikes, electric scooters, electric scooters, electric quads, scooters for the disabled. So on every electric vehicle that has a brushless motor (you can guess if the motor is brushless from the exit of three yellow, green and blue wires from the motor).
- We also recommend purchasing our universal display to make sure your controller works properly.
Measures:
LENGTH: 8.5cm
TOTAL LENGTH: 9.5cm
WIDTH: 5cm
HEIGHT: 3cm

Technical data:
MODEL: KT24/36ZWSRT-PXS24L
RATED VOLTAGE: DC24V/36V
RATED CURRENT: 7A
MAXIMUM CURRENT: 15A+-1A
LOW VOLTAGE PROTECTION: DC20/30+ - 0.5V
SPEED SET: 1-4.2V

24/36/48 Volt KT LCD Display for Electric Bicycles - UPG Connection
This universal display has the ability to operate at three different voltages in fact, it can work both at 24v, 36v and 48v.
- This universal display can work with all brushless motors (without brushes) but hardly interfaces with the standard bike ECUs.
- This universal display does not necessarily interface with the bike's standard ECU, so in case of difficulty we recommend purchasing the universal kit: display plus ECU.
Technical data:
5 levels of assistance
speed'
full speed
average speed
total km
partial km
engine usage time
switch on display lights
6 km / h function
battery level

PAS Sensor Pedal Assist KT-V12L with UPG connection
This pedaling sensor (PAS) is mounted on the left side of the bike.
To install it, the crank arm must be disassembled and then reassembled by tightening the PAS firmly on the axis of the bottom bracket

1T4 wiring harness for display-brakes-accelerator - UPG
- Length 133cm
UPG bindings for:
- Brakes (Red)
- Throttle (Yellow)
- Display (Green)
MEASUREMENTS: Length: 133cm

For any technical information on assembly and compatibility, the technicians are available on 3206140014 also with a whatsapp message. Capobranco Project is not responsible for tampering or incorrect installations. On the control units for electric bikes, scooters and electric scooters, Capobranco Project guarantees a 1-year warranty. Our products are stored and shipped from our headquarters in Italy.